Marque Type II Squad 2

The Type II model for Marque ambulances is called the Squad 2.  The Squad 2 comes in either a Ford E-350 or the Dodge Sprinter chassis. The Squad 2 model comes with many great features from the body to the warning lights and sirens to the interior.

Body Features

• Aluminum Step Rear Bumper: Grip-strut flip-up center section to facilitate loading
• Coax Antenna: (1) RG-58AU from ceiling to behind driver's seat
• Roll Cage: Full length, fully welded steel superstructure
• Front Wall: Walk through or pass through design
• O2 Storage: Curbside rear wall

Environmental Features

• A/C - Heater System: 650 CFM blower unit, 32,000 BTU A/C-40,000 BTU heating
• Vents, Power: Marine style
• Insulation: 3" fiberglass batts

Warning Lights & Siren Features

• Flasher: Vanner Solid state
• Intersection Lights: (2) 7” X 3” Red LED
• Grille Lights: (2) Red LED
• Warning Lights: (10) 9” X 7” Halogen
• Load Lights: (2) 9” X 7” Halogen
• Scene Lights: (4) 9” X 7” Halogen
• Siren: Whelen WS-295HSFA7
• Speakers: (2) 100W Drivers
• Back-Up Alarm: 97 Db with momentary cutoff

Interior Features

• Interior Height: Minimum 65" of headroom
• Dome Lights: (6) Dual Filament, Incandescent, Two rows of three each, switched separately
• Spotlight: (1) 400,000Cp Hand-held light w/momentary switch
• Cot Mount: Ferno-Washington 175-5
• Squad Bench: Backboard slot and storage underneath
• Laminate: Post form grade interior
• ALS Cabinet: Storage for trauma kits, Mon./Defib., Medical cabinet, located at front bulk head
• Hazardous Waste / Sharps Disposal: Drawer in the end of the squad bench
• Flooring: Rolled up sidewalls 4" non slip Loncoin
• Aspirator: Disposable with electric vacuum pump  
• IV Holders: (2) Dual, swing down rubber holders W/Velcro retaining straps
• Drug Cabinet: With latch under attendant seat

Power Distribution/Electrical Features

• 12 VDC Outlets: (2) Cigarette style one in action area, One in ALS
• 115 VAC Outlets: (2) Duplex; One in action area, One on curbside wall
• Shoreline: 115 VAC, 20 Amp With mating plug with GFI protection
• Etched-Trace Power Circuits: HD-3 Oz. for increased service life
• Etched-Trace Control Circuits: HD-3 Oz. for dependable service
• Marine Grade High Current Switches: Replaceable, for milllamp circuit, to improve switching dependability
• HD Machine Crimped Harness: Pull and load tested, prewired for halogen or LED Lighting systems provides a rugged dependable network
• Inverter: Prewired for Vanner inverter
• Clock: LED in rear control panel